loading
reading
writing
saving
searching
Marshall JCM 600 - $525 (Tujunga)
commerce ave near foothill blvd
QR Code Link to This Post
(This is a lower powered version of a JCM 900)
60 watts power from 5881 tubes (a type of 6L6 tube). This amp can also use 6L6 tubes! (cannot use EL34 tubes).
The amp has a BIAS control, set the correct bias for your tubes!
2 separate channels, each has their own tone controls and their own REVERB!
2 effect loop types, parallel and serial!
Presence control!
D.I. Output using an XLR connector!
The JCM 600’s D.I. Out is switchable
between a speaker Emulated signal (pre the
power amp), and a non Emulated (post the
power amp ) signal.
The Emulated Output captures the tonality of
Vintage loudspeakers like no other D.I.
furthermore this output is unaffected by the
Master Volume controls therefore allowing
the JCM 600’s output to be turned off whilst
still providing silent recording facilities!