favorite
favorite
hide
unhide
flag

Posted

print

Blacksmith Post Vise Work Station - $1,000

Blacksmith Post Vise Work Station 1 thumbnailBlacksmith Post Vise Work Station 2 thumbnailBlacksmith Post Vise Work Station 3 thumbnailBlacksmith Post Vise Work Station 4 thumbnailBlacksmith Post Vise Work Station 5 thumbnailBlacksmith Post Vise Work Station 6 thumbnailBlacksmith Post Vise Work Station 7 thumbnailBlacksmith Post Vise Work Station 8 thumbnailBlacksmith Post Vise Work Station 9 thumbnailBlacksmith Post Vise Work Station 10 thumbnailBlacksmith Post Vise Work Station 11 thumbnailBlacksmith Post Vise Work Station 12 thumbnailBlacksmith Post Vise Work Station 13 thumbnailBlacksmith Post Vise Work Station 14 thumbnailBlacksmith Post Vise Work Station 15 thumbnail
Blacksmith Post leg vise 5 inch jaws
Disassembled, defunktified, lubed.
Opens closes easily, locks down tight.
Mounted to this HEAVY DUTY work stand.

Super efficient setup. Rock solid vise mounted to rock solid platform & plenty of surface area to work on.
It's not too hard to tilt back and roll/spin from spot to spot but once it's flat, it's very secure & stable.

Bottom plate of stand about 26 inches diameter & almost 3/4 in thick.
Top plate 1 inch thick & plenty of surface area to work on.
Bottom plate & vertical post pushes 150 lbs

Top plate alone is easily over 100 lbs.the whole setup gotta weighs around 300 lbs.
Very solid and stable setup.
From floor to top plate is 32 inches
From floor to top of vise just under 41 inches
Was told the base ( not including the top plate ) was from those windmills out in the desert

post id: 7746462673

posted:

updated:

best of [?]

loading
reading
writing
saving
searching